Repair / Problems / Controls and cables / Throttle cable keeps fraying or breaking at the grip end

Controls and cables

Throttle cable keeps fraying or breaking at the grip end

Do not rideAlso called: throttle cable snapped, broken throttle cable, throttle cable frays at the grip, cable end pulled off

Cable leaving the grip housing in a gentle curve
Cable leaving the grip housing in a gentle curve
Grip tube pulled out to reach the cable end
Grip tube pulled out to reach the cable end
Cracked cable outer on an old bike
Cracked cable outer on an old bike

Most throttle cables fail at the twist grip end. Each time the grip turns, the wire bends where it leaves the grip, and broken strands start there. A cable that breaks again soon after replacement points to a cause at the grip: a sharp bend, a dry or dirty grip, or a cable that is too tight.

Is it safe to ride?

No. A frayed throttle cable can catch and hold the throttle open, or snap and leave you with no power. Replace it before riding.

Quick checks first

  • Open the grip housing and look at the cable end for broken strands.
  • Does the cable leave the housing in a gentle curve or a sharp bend?
  • Turn the bars lock to lock: does the cable pull tight or kink at either side?
  • Is it the right cable for the bike (length, ends, single or twin)?

Diagnose it step by step

1Are there broken strands near the cable end at the grip?

2Does the cable enter the grip housing at a sharp angle, or has the housing been turned on the bar?

  • Yes: set the housing to its original position (many have a locating pin or a mark). The cable must enter in a gentle curve.
  • No: go to step 3.

3Is the grip stiff, dirty or dry with the cable unhooked?

4Does the cable pull tight or kink when the bars turn, or is the free play almost zero?

5Is the outer cracked, or is the cable a cheap or wrong-length copy?

Causes, most likely first

Cause How to confirm Fix
Dry cable end at the grip Broken strands, no oil at the end Replace and lubricate
Sharp bend at the grip Housing turned, cable kinked at entry Reposition the housing, gentle curve
Stiff or dirty grip Grip hard to turn with cable off Strip the grip
Cable too tight or misrouted Idle rises at full lock Adjust free play
Cracked outer Water and dirt inside Replace the cable

Related problems

Sources

Values marked K-Light 125 are for that reference bike. Use your own bike's manual for its values. Text CC BY-SA 4.0, Transitions Lab.