Repair / Parts / Throttle twist grip (throttle tube and housing)

Chassis, steering and suspension

Throttle twist grip (throttle tube and housing)

Also called: twist grip, throttle tube, throttle sleeve, throttle housing, throttle drum, thumb throttle

Find this part →

Throttle twist grip (throttle tube and housing)
Single cable twist grip: tube, housing and cable
Single cable twist grip: tube, housing and cable
Handlebar layout with twist grip, levers and cables
Handlebar layout with twist grip, levers and cables

The throttle twist grip is the tube under the right grip and the housing that clamps round it on the bar. The tube has a drum or channel that holds the end of the throttle cable. On many bikes the housing also carries the right-hand switches (engine stop, starter, lights). ATVs and some scooters use a thumb lever instead.

What it does

Turning the grip pulls the cable and opens the throttle. Designs differ: a drum with the cable in a gentle curve, a straight pull with no bend, a twin cable drum (pull and return), a spiral groove that slides a block in the bar, or a small gear set. The less the cable bends at the grip, the longer it lasts.

Signs it is worn or failing

When to replace it

Replace a cracked tube, a tube with a worn cable channel, or a housing with stripped screw holes or a broken switch.

What to match when buying

  • Make, model and year. Single or twin cable drum. Drum size changes how fast the throttle opens: keep the original unless you know why you are changing it.
  • Housing with or without switches, and the right connector.
  • Bar diameter and whether the housing has a locating pin for a hole in the bar.

Fitting notes

  • Clean and lightly grease the bar under the tube. Grease spiral and gear types; light oil or graphite on cable drums.
  • Set the housing so the cable enters in a gentle curve. Check the throttle snaps shut at every bar position.
  • See Strip, clean and lubricate a twist grip.
Sources