Repair / Parts / Carburettor jets (main, idle, needle jet)

Fuel and air

Carburettor jets (main, idle, needle jet)

Also called: jets, main jet, pilot jet, idle jet, needle jet

Find this part →

Carburettor jets (main, idle, needle jet)
Round and hex main jets of different sizes
Round and hex main jets of different sizes
Main jets in brass and plastic
Main jets in brass and plastic
Main jet washers beside a main jet
Main jet washers beside a main jet

Jets are small brass parts with a metered hole. They set how much fuel the carburettor draws at each throttle opening. The idle (pilot) jet feeds idle up to about one quarter throttle. The needle jet and jet needle feed the middle range. The main jet feeds from about two thirds throttle to full throttle. The ranges overlap, so the change of one affects the others.

What it does

Vacuum in the throat of the carburettor draws fuel through each jet and into the air stream. The size of the hole and its position decide how much fuel is drawn at each throttle opening. Most idle jets screw in. Some newer ones are pressed in and cannot be changed.

Signs it is worn or failing

When to replace it

Replace a jet that is cracked, has worn threads or a damaged hole, or will not pass light after cleaning. Change the size only for a reason, such as a new exhaust or filter, and work by the maker's size table. See Change the main jet and read the plug.

What to match when buying

  • Make and model of the carburettor (Mikuni, Keihin, Bing, Amal and others).
  • The number stamped on the old jet, and its thread and shape (round or hex head).
  • Genuine jets carry the maker's mark. Copy jet kits are cheap but often have poor quality and the wrong hole size.

Fitting notes

  • Handle small jets with care. Do not strip the thread or break the slot.
  • Keep any washer or O-ring under the jet.
  • After fitting, check light passes through the hole. See Clear carburettor jets and passages.

Videos: how it works

How-toS&S Cycle - Carb Jetting and Tuning - S&S Super E & G CarburetorS&S Cycle, Inc · 17:31 · YouTube

Maker guide to jetting S&S carbs; jet sizes are for those carbs only, but the method transfers.

Videos by their creators on YouTube, chosen because they show this clearly. Values in a video are for the bike shown; use your own bike's manual.

Sources